Complete stereo upgrade fitting kit to install a Double DIN aftermarket radio and retain the use of the steering wheel controls in Volvo XC90 (2002-2014) models (Without Parking sensors)

Package Includes

• Double Din Fascia cage kit
• Steering Wheel Control Interface
• Antenna Connector and Extension
• CAN Bus Connector
• Amplifier Bypass Cable
• Universal patch lead (Included)

For cars that have original parking sensors, please use fitting kit FK-860-PDC

Fascia Adaptor

This adaptor will convert the non din-sized aperture left after removing the factory stereo to a din size ready for head unit installation. The high quality finish, colour and texture are designed specifically to maintain the original look of your vehicles interior.

Replacement car audio fascia to enable you to change the original radio in the car to a Double DIN aftermarket version
Includes cage kit so the aftermarket cage supplied with the new radio will not be needed.

Steering Control Adaptor

A stalk/steering wheel control adaptor enables you to utilise the original factory remote audio (whether built onto steering wheel or fitted on a stalk next to the steering wheel) with an aftermarket unit. 

This interface uses loose wire connections behind the original radio to allow the use of the original steering wheel control buttons with a new aftermarket head-unit. It also provides CANbus outputs as well as Ignition, speed pulse, reverse gear, handbrake and illumination signals to the new stereo. Includes PHONE functions on compatible radio's.
This interface comes with a universal patch lead which can be used with Alpine, Blaupunkt, Clarion, Pioneer, JVC, Kenwood, Sony or Zenec Head-units.

This interface does not drive the audio and so the cars amplifier needs to be bypassed, use item 20-307 from this kit to bypass the amp

Antenna Connector and Extension

This cable converts the car radios existing aerial plug in the rear roof to DIN type used by most car radio manufacturers.
On some Volvo XC90 models, there is no antenna connector behind the radio, it is in the roof at the rear of the car. If this is the case you will need to remove the rear roof lining and locate the cars antenna system and run a antenna adapter extension cable 21-148 along the left side of the roof trim. If your Volvo XC90 already has an antenna connection behind the car radio then this part is not needed.

Cars in USA do not have the antenna connector in the roof. In these cars you will need to fit a new antenna

Amplifier Bypass Cable

Allows you to connect a new aftermarket radio directly to the cars speakers after bypassing the original amplifier. The original amplifier in the car has fibre optic connections from the head unit. When replacing the head unit it will be necessary to bypass the fibre optics and ignore the original amplifier.
This lead is designed to be used along with a steering wheel control interface and a parking sensor retention interface.
When bypassing the amplifier, the original subwoofer will no longer work. Additional wires are on this lead to enable the installation of an aftermarket amplifier to drive the subwoofer.

CAN Bus Connector

This cable allows you to keep the CANbus system in a Volvo XC90 active when installing an aftermarket head unit. The link lead has a dedicated connector allowing the user to connect up to two CAN interface devices to a Volvo XC90 vehicle.

Important Fascia Notes

• The fascias are made to suit industry standard sized stereos such as Pioneer, Kenwood, Sony, Alpine, JVC etc, NOT INCLUDING China units or unbranded units. 
• China units have a reputation to be over sized and may require modification to the fascia to allow it to fit.
• We do not take any responsibility for China units not fitting as they are not industry standard size.

Car Audio Fitting Accessories are sold with limited instructions. Some knowledge of car audio installation is helpful, as in some rare case "modification" is necessary.

Please make sure that is the correct Fitting Kit for your vehicle by firstly checking to see if your vehicle make, model and year is listed in the description. Secondly by checking to see if the connection & Shape in the picture listed is the same as you have in your vehicle. If in doubt please email us with your vehicle details and we will confirm what you require.